How to make a 3d photo

December 15, 2009 at 10:20 am · Filed under 3d, Digital Imaging, participation and tagged: 3d

Peep below…follow the instructions to create an ANAGLYPH (3d with red and blue)photo..

1. Obtain two stereo pair photos. (I often use two disposable cameras mounted on a board side by side and with an ever so slight convergence towards the horizon. Remember you’re mimicking your eyes and your eyes always end up focusing on something–each eye can never look straight ahead separately. I find the best anaglyphs work with a very low level of convergence. This is usually evident by the amount of red/cyan silhouetting around objects in a scene.)
2. Scan each photo separately. (I would recommend desaturating them to make them B&W.)
3. Open left photo in Photoshop (just like your eye, the left photo is identifiable by the fact that objects within the scene are more to the right when overlayed with the other eye.)
4. From the color selector, select color #00FFFF (bright turquoise). The equivalent of this in RGB is R-000 G-255 B-255.(This is also called cyan).
5. Create a layer above the left photo and fill it with this color.
6. Duplicate this layer and go to Image > Adjust > Invert. This will change the color of this duplicate cyan layer to a red color (direct opposite). In RGB the color created will be R-255 G-000 B-000.
7. Open the right photo and copy it, close it and in the left photo (the one to which you added the colored layers), paste it below the red layer.
8. Now position the 4 layers as follows: The bottom is your right photo. Above it is the red layer. Above it is the left photo and above this is the cyan layer.
9. If you wish to check the alignment of the two photo pairs you can turn off red and cyan layers and adjust the opacity of the left photo to 50%. Make sure both photos are on the same vertical plane and shift up/down appropriately. When finished change the opacity of the left photo back to 100%.
10. Turn on the cyan layer and change the transfer mode to screen.
11. Merge the cyan and left photo layers together. You should now see a very abstract cyan tinted image that will be hard to distinguish in areas.
12. Turn off this new cyan layer.
13. Turn the red and right photo layers back on and change the red transfer mode to screen. (Note: You don’t need to merge these two if you don’t want to.) Again you’ll see an abstract red image similar to the cyan before.
14. Turn on the new merged cyan/left photo layer and change the transfer mode to multiply. Put on glasses (red on left, cyan on right) and you should now see the anaglyph.

1. You may wish to change the red/right layer’s opacity to somewhere between 80 and 90%. Do this as you wear the glasses as it will make the adjustments easier. Remember in order to do this you need to add a white layer below the right photo (or red color/right photo merge) so you don’t see the transparency squares beneath the photo if you started with a transparent background. You could also move this layer left or right to make adjustments to the alignment.
2. At the end you can merge down the image by going to Image > Flatten Image and save it as a JPEG image with the quality setting of your choice for simplicity so you don’t have to save it as a layered Photoshop .psd picture.

Comments (1)